With the purchase of the T-variation of High-Z cnc-router you get a proven technology with a certain icing of the cake. High-Z/T cnc-routers was conceived for once more precision (repetition precision approx. 0,02mm) and especially for higher traverse speed.

Because of the used ball screws the High-Z/T 3D-cnc-engravers achieves a fantastic precision and an almost unmeasurable back lash of  approx. 0,01mm. At the same time there are high traverse speeds up to approx. 108mm / sec. ( 6.500 mm/min ) possible.

With this cnc-machines you’re able to carry out an engrave and mill speeds of approx. 4500 mm/min. and express travels up to 6500mm/min.

This 3D-milling-machine series is usable in the industrial field as well as for works like engraving, milling, drilling, measuring, cutting and measuring out systems as for example adhering of adhesive on 3D outlines.

All cnc-machines are being delivered with black energy-chains on all axis, which allows a better cabling management.  Also, all cnc-engraving-machines are equipped with an emergency stop button. An additional emergency stop you find in front of the controller.

Basic equipment of all High-Z CNC-milling machines:

Software ConstruCAM-3D ( from S-720 and S-400/T ) included !!

Contact free reference switch and emergency stop button as well as 22mm thick linear guide ways and individually adapted screw nuts !!

Equipment / Productdetails:

• Drive : 4 stepping motor by Nanotec with 1600 steps/rev    (1/8 Step)
• 2 motors for constant tension and compression during milling operation on X-Axis
• Guide ways X and Y axle 22 mm / Z Axis 16mm, grinded and with 61hrc hardened surface
• Feed through of long workpieces possible, because there’s no belt drive at the end of the X-axle
• Ball bearings at both sides of ball screws on X and Y axis
• Traverse speed of rapid feed: max. 7000 mm/min
• Technical resolution : 0,00625 mm ( 1/8 Schritt )

• Reversal error max.: +/- 10µm ( 0,01mm )

• Table size / clamping area: 730 x 400 mm
• Traverse Paths: X=400 mm; Y=280 mm; Z= 110 mm
• Reference- and limit switch on all axes
• Double safety emergency stop button
• Energy chain for clean cabling
• Total dinemsions incl motors: L x W x H = appr. 730 x 520 x 500mm
• Milling Motor anchorage: Euroneck Ø43mm
• incl. Software PC-NC or WIN PCNC Light

• incl. Software ConstruCAM-3D ( recommended sell price 1902.81 EUR)

• Modular frame for universal application
• Weight appr. 31 kg
• Complete machine Includet 4 driver microstep controller 4x 2,1 Ampere
• An approx. 30-minute long introduction during pick up and an unlimted telephone support are included.
• An approx. 2-3 hours long introduction and an installation of software on your brought note book/ PC as well as a explanation of fundamental terms of Corel Draw etc. possible, too.

More information, several videos about the applicability of the machine and customer implementations can be found here.

The name High-Z derives from the fact, that the machines lower contruction allows to work on pieces with unlimited height.